XR 11 remote works only in line of sight
Been meaning to ask this for a while. Contour 2, Cisco 9865HDC DVR, Cox XR 11 remote. Even with battery levels at 100%, this remote will function *only* when pointed directly at the box.
By compari...
Forum Discussion
Hello Chaloots,
The steps for pairing the Contour 2 remote are listed below. Thanks
1.Ensure the following:
•Batteries are installed in the remote.
•Your TV is on and set to the input for the Contour 2 receiver.
•Your receiver is on.
2.Press and hold the Setup button on the Cox remote for three seconds, until the red LED on the remote turns green.
3.Press the Contour (Menu) button.
Result: The LED on the remote flashes.
4.Do one of the following:
•Follow the pairing instructions displayed on the TV and enter the three-digit code
•Press the Contour (Menu) button again and repeat until the instructions display. Then, enter the three-digit code.
Result: The receiver and remote are paired.
The steps for pairing the Contour 2 remote are listed below. Thanks
1.Ensure the following:
•Batteries are installed in the remote.
•Your TV is on and set to the input for the Contour 2 receiver.
•Your receiver is on.
2.Press and hold the Setup button on the Cox remote for three seconds, until the red LED on the remote turns green.
3.Press the Contour (Menu) button.
Result: The LED on the remote flashes.
4.Do one of the following:
•Follow the pairing instructions displayed on the TV and enter the three-digit code
•Press the Contour (Menu) button again and repeat until the instructions display. Then, enter the three-digit code.
Result: The receiver and remote are paired.
