Forum Discussion

jeffareid's avatar
jeffareid
New Contributor
4 years ago

Recorded programs corrupted on Cisco box

List of errors:

After a program was recorded, was able to playback the entire recording without issue one time only. A second attempt to play back the recording gave error code 2.1.2.1

A program was recorded while also watching live without issue, but even the first playback failed with error code 2.1.2.1

A corrupted recording showed 1171 minutes, but only had about 6 minutes of recording and skipped to end.

A Monday 10 pm recording played back for about 5 minutes, the switched to a prior Friday 6 am program that was not recorded.

We have had corrupted programs ever since Cox switched us from Motorola to Cisco box. I've exchange the Cisco box 3 or 4 times, and all of them have had the same corrupted recording issues.

  • CurtB's avatar
    CurtB
    Valued Contributor III

    If the 3 or 4 cable boxes were exchanged over a long period of time, then you've been very unlucky.  But if you exchanged all of them within a short period of time to fix corrupted recorded programs, it's more likely that you have a signal issue.  You should schedule a tech visit to check your signal strength, including at the tap.  If your cable comes in from a pole, be sure to specify when scheduling the appointment that you need a tech with a ladder.

    • jeffareid's avatar
      jeffareid
      New Contributor

      The first few exchanges were within months of each other. Some of the techs that came out were aware that the Contour 1 Cisco boxes were prone to getting error code 2.1.2.1 and other corruption issues. In cases where a playback worked once, but failed later, that would not have been a signal issue, since it had played back correctly once. I've been told that the Contour 2 versions of the Cisco boxes may fix the corruption issue. 

      • CurtB's avatar
        CurtB
        Valued Contributor III

        It's possible you've had 3 or 4 bad boxes, but it's unlikely.  Typically when people exchange cable boxes several times, they later find there was a signal issue.  An error can occur during playback of a recorded program that's been watched before.  When you press a key on the remote to pause, FF, reverse, etc., the remote sends a command to a Cox server.  When a signal issue is occurring, the DVR waits for a response it never receives.  A signal issue during recording will cause an error at that point during playback.

        I've personally experienced erroneously reported recording times of over a thousand minutes.  The cause was found to be a main line signal issue.  When that signal issue was found and corrected, DVR recording and playback issues stopped.  Were the techs that told you the issue was due to the cable box and/or told you Contour 2 would solve your issue contract techs?  Have you ever had an in-house Cox tech check your signal strength at the tap?  If you know the neighbor that shares your tap, ask them if they've had any cable issues.  Even if the neighbor says no, your issue could still be caused by a faulty port at the tap.

    • jeffareid's avatar
      jeffareid
      New Contributor

      Techs have come out multiple times, and signal strength is good, at the DVR all the way back to the junction box. There is a cable amplifier that feeds to a splitter for cable modem, DVR, and phone.

    • jeffareid's avatar
      jeffareid
      New Contributor

      In some cases after getting an error code 2.1.2.1, after power cycling, I was able to play back a recording, sometimes without issue, sometimes with a skip to end, the most recent a 3 1/2 hour recording that froze up at 2 1/2 hours, that was watched once without issue, then got an error code 2.1.2.1, then the next day it would play but freeze up at 2 1/2 hours. This has been pretty much the pattern with all of the Contour 1 Cisco DVRs we've had.